Steel Rim - Wheel Nut Taper

[W&KO]

Chasing the taper in degrees on wheel nut / steel rims.

Cheers

[p38arover]

Do you have a wheel nut? If so, use a bevel gauge (if you have one) set to the angle, then look at it on a protractor.

If no one else can help, I'll have a look this afternoon.

[Bigbjorn]

Do you have a wheel nut? If so, use a bevel gauge (if you have one) set to the angle, then look at it on a protractor.

If no one else can help, I'll have a look this afternoon.

Double handling! Use the protractor on a combination square.

[Ancient Mariner]

40 deg by lathe top slide

[p38arover]

Double handling! Use the protractor on a combination square.

I must buy one of those one day.

[W&KO]

40 deg by lathe top slide

Thanks....