Bulkhead measurement needed

[akelly]

Hey all - I wonder if someone could take a measurement from their IIA 4 Cylinder bulkhead for me? I need to know the width of the strip that forms the bellhousing cover, as shown in the pic. Also need to confirm it's a uniform width all the way across.

161640

Cheers,

Adam

[Cadas]

Hi

https://uploads.tapatalk-cdn.com/20200531/cb26d44853be93af0aba2da2ba7c4b7c.jpg
69mm here, same to the bottom, and stays 69mm to the top bolt hole.

https://uploads.tapatalk-cdn.com/20200531/cd9732860ddb40dc9859d60a102bcc49.jpg
At the bend where the ruler is pointing it starts to widen

https://uploads.tapatalk-cdn.com/20200531/e4dbdd7c42c98b42e91ec1d9575ddb92.jpg
Then it’s 80mm at this point.

It continues to widen as it continues to the floor to maintain a vertical edge.

[akelly]

Brilliant! Thanks so much. Now I can get on with finishing my bulkhead conversion from 6cyl to 4cyl.

Cheers,

Adam