View Full Version : Td5 alternator W terminal
TheEntertainer
2nd July 2020, 04:55 PM
Hi all,
On the td5 2003 alternator, can some one please point out the’W’ terminal used for tacho?
My understanding is it’s one of the three screws on the pic below on the back of the alternator.
Thanks
Jhttps://uploads.tapatalk-cdn.com/20200702/9813b2bbdaed26b2ce009429131bc3ea.jpg
theelms66
2nd July 2020, 09:37 PM
Those three "screws " you say are nothing more than mounting fasteners for the internal rectifier. Your "w" terminal will be for charge warning light in the instrument cluster. W terminal is in the 2 pin connector. I fairly certain .
Lemo
3rd July 2020, 06:37 AM
162605
copy of the wiring from RAVE attached
NY - to Inst Pack warning lamp and also goes via a header to the ECU
WG - from fuse 24
It's my understanding the tacho gets its signal from the ECU
Lemo
INter674
6th July 2020, 07:02 PM
W terminal won't be present on TD5..ecu signal from CAS more likely for tach.
However its easy to fit one if needed..just pull apart and solder a wire on one of the usual 3 field winding terminals before the diode bridge. Then need to use a decoder eg Dakota to run a tacho.
Discofender
12th July 2020, 06:38 PM
Recently fitted a tacho to my td5 with a repro of the factory on, single wire from pin 19 on the black plug to ecu. Early ecus this is blanked off, later one it also feed the ABS ecu. Then a positive feed from ignition and seperate one for the dash light.
Cheers
Parker
7th September 2020, 09:08 PM
Recently fitted a tacho to my td5 with a repro of the factory on,...
Cheers
Which tacho did you buy?
Discofender
7th September 2020, 09:35 PM
From Rimmer Bros,
Rev Counter Kit - LR1200 | Rimmer Bros (https://rimmerbros.com/Item--i-LR1200)
Powered by vBulletin® Version 4.2.4 Copyright © 2026 vBulletin Solutions, Inc. All rights reserved.