Jon W
31st May 2021, 07:06 PM
Hi all
This is my first post on the AULRO forum - apologies in advance if I have not followed all protocols.
I am lucky enough to have completed an overland trip from Singapore to London in a 110 TD5 Defender a few years back. Here is a picture of the car in Mongolia. We blew a diff in the Gobi Desert a little later - but other than that the car didn't miss a beat over 53,000km.
171299
Privacy in a roof tent can be a challenge in busy locations, like downtown Beijing. So, we are now starting to build a camper based on a 130 Puma with the help of Styromax. The drawing below shows what we are planning. It will be a pop-top so it can fit in a container (assuming we can travel overseas one day...). Our starting-point has been a dual-cab, which has been pretty simple to strip down to and install a sub-frame to take the camper body.
I do need some help with finding a fabricator, preferably knowledgeable about Defenders, who can help cut the roof panel and fabricate the side panels behind the B-pillar to join the cab with the camper box. I'm based in Brisbane, so any recommendations in SE Qld would be appreciated.
171300
Thanks for your help.
Regards, Jon
This is my first post on the AULRO forum - apologies in advance if I have not followed all protocols.
I am lucky enough to have completed an overland trip from Singapore to London in a 110 TD5 Defender a few years back. Here is a picture of the car in Mongolia. We blew a diff in the Gobi Desert a little later - but other than that the car didn't miss a beat over 53,000km.
171299
Privacy in a roof tent can be a challenge in busy locations, like downtown Beijing. So, we are now starting to build a camper based on a 130 Puma with the help of Styromax. The drawing below shows what we are planning. It will be a pop-top so it can fit in a container (assuming we can travel overseas one day...). Our starting-point has been a dual-cab, which has been pretty simple to strip down to and install a sub-frame to take the camper body.
I do need some help with finding a fabricator, preferably knowledgeable about Defenders, who can help cut the roof panel and fabricate the side panels behind the B-pillar to join the cab with the camper box. I'm based in Brisbane, so any recommendations in SE Qld would be appreciated.
171300
Thanks for your help.
Regards, Jon