Top Windscreen Moulding

[Parso]

So I'm driving home this afternoon @ 100km/ph feeling good about holidays tomorrow when I hear a thudding on the roof. I pull over and check the maxxtraxx are still there and lo and behold my top windscreen rubber moulding has blown off. I had the windscreen replaced in January and it seems the boys at O'briens were a bit stingy with the glue.
TL;DR - The car is loaded to the gunnels and I need a seal to stop the rain getting in. Does anyone know if something generic will fit or am I looking at an online order?

[josh.huber]

I would use a decent quality race tape or duct tape in the first instance.

[Airmech953]

I don't think that the top moulding is a weather seal - just a trim strip. The glue that holds the screen in should keep water out.

[BushDisco]

Had the same issue a couple of years back. Used black guttering silicon to fix it in place. Took it fully off and cleaned it first.

[Parso]

Thanks for the peace of mind guys. I might tape it up until a replacement comes for aesthetics