Radiator Hose and Thermostat to front Rail Hose Sizes

[RRT]

Going to source a hose to replace the manufactured ones I made up when I took out the thermostat. So am wanting to source a pipe to go from the radiator to the front coolant rail as a single entity but need to know the

However did not measure the hose sizes at either end, just used the old hoses and stuck a pipe in between them. Strange now I think of it, the Silicon hose set did not include these in the set yet did have the hose to the waterpump.

Just need to know the diameters of these if someone has them available or can confirm

Radiator to Thermostat - 34mm internal Diameter as per the following

Attention Required! | Cloudflare (https://www.motor-doctor.co.uk/products/15905840-radiator-hose)
Attention Required! | Cloudflare (https://www.motor-doctor.co.uk/products/14544497-radiator-hose)

The thermostat to the coolant rail though I have not been able to find the dimensions of. This is the pipe number
Radiator Thermostat Hose Bottom Land Rover Discovery 2 TD5 PEH101110A

176848
176849

[sierrafery]

Here you go for the PEH101110 Please Wait... | Cloudflare (https://www.trodo.com/heater-hose-gates-02-1947)

[RRT]

Here you go for the PEH101110 Please Wait... | Cloudflare (https://www.trodo.com/heater-hose-gates-02-1947)

Much appreciated, as with so many parts for the D2 which include bolts and pipes etc. there is very little information out there of these.

So based on this info the hose is 34mm to 33.5mm, so guessing with this the variation is a natural one and a 34mm to 34mm hose will suffice, thanks again!!

[RRT]

Off to supercheap this morning and a TJ Magna upper hose, 34mm and more than enough length and $24, DONE! THanks
176893