Roof wiring via outside A pillar

[Disco4TT3]

I know there are lots of posts re> this - but I’m struggling to find the answer I’m looking for.

I have a wire running thru the grommet in drivers footwell and thru the interior sills to the back of car - no worries.

But how do I get it from the engine side of grommet to the outside drivers A pillar?

There seems to be some steel sheeting between the engine side where the brake booster is and the underside of the wiper surround where I need to get to for routing up the outside of the A pillar to the roof - presumably.

Anyone have an idea to route this that doesn’t involve going to the other side of the car where the antenna grommet thru the wiper surround is?

Cheers

Kev

[Disco4TT3]

For anyone else finding this post, I used the passenger side A pillar, then ran along the lip around the bonnet seal and into the engine thru a small gap under the seal, right near the secondary battery tray. Then around the back of the engine and in thru the drivers footwell.

[loanrangie]

I will be attempting this shortly once I get motivated to finish off my light bar wiring.