Spigot Bush for a Holden Engine Conversion.

[mick88]

I know clutch/crank spigot bushes to suit Holden conversions in Series Land Rovers are hard to find these days,
so I have machined some up. They are made of sintered bronze, so once saturated with oil they will retain good
lubrication properties.
See the for sale section for full details.


Cheers, Mick.

[Rdawes]

Hey Mick, I had a quick look online and couldn’t find the specific bush i am after. Do you by any chance have a bush to suit a Holden 186 to series 3 gearbox?

I can’t find any information on sizing or supply anywhere.

[Mustlust]

As above, cant find link or contact details?????

[Jglover]

G'day Mick,

Do you still have these bushes available?

Regards,

James

[gromit]

G'day Mick,

Do you still have these bushes available?

Regards,

James

I'm not sure if Mick visits the forum very often nowadays.

If you know the OD, ID & length it might be possible to source from a bearing company.



Colin

[mick88]

Hi James,
yes I do have them available, however there are a few variants, so I need to know
what conversion/flywheel set-up you have. Is your existing spigot bush located in the
centre of the crankshaft or in the flywheel itself.
Drop me an email with some photos of your set-up.
jillnmick2002@yahoo.com.au
Phone 0427 245067

Cheers for now,
Mick.


G'day Mick,

Do you still have these bushes available?

Regards,

James

[mick88]

G'day Colin,
They are mostly a non standard size, so exclusive to the conversion.

Cheers for now,
Mick.



I'm not sure if Mick visits the forum very often nowadays.

If you know the OD, ID & length it might be possible to source from a bearing company.



Colin