Automatic transmission cooler lines. Any preferred suppliers/mods?

[ILikeDirt]

Finally in position to start seriously digging in and getting everything squared away.

[RRT]

Know some people like to add a secondary trans cooler, but for mine the larger P38 was more expedient for me and less hoses etc. The P38 has screw fittings not the push fittings which I also fitted to the lines from the auto as well. This was done by Pirtek and I added another couple of inches to the length luckily which made the fitting pretty simple. Be sure to specify high burst hoses as well due to the pressure the lines run which are a lot higher than most autos.

Connected up to P38 Trans Cooler
180140

Line from auto

180138

The only mod needed to fit the P38 Auto cooler (also have the Serck intercooler so space is not a issue) was a bracket which was pretty simple to fabricate.

180141

P38 fitting

180139

also required the right angle joints as it is a little tight to try and bend the hose around to square it to the fitting

180135




Pirtek hoses for the ACE system.
180136
180137