Bump stop clearance

[walker]

Does anyone know what the front and rear bump stop clearances are at standard ride height?

Thanks

[walker]

Ok, so no one know the answer.

Is someone able to measure from centre of wheel to guard for me when at standard height. I read on an American site that standard is around 20" but just want to confirm this.

[130camper]

I think I saw somewhere that you have the vehicle sitting on coil springs so this may only be of limited interest to you.

https://uploads.tapatalk-cdn.com/files-1089/EAS20-20Beginers2028Rev29.pdf

The Absolute Beginners Guide to the Range Rover P38 Electronic Air Suspension

Page 20 does give the length of the blocks needed to set the EAS .... not exactly bump stop to housing that you may be after but may give some idea.

Andrew.

[walker]

Thankyou. Yes I had read that, and decided it was close enough.
Also managed to measure someone's P38 last night to confirm.

I found a few great Facebook groups for the car. It seems Aulro is pretty much dead as far as the P38 is concerned.