Nanocom not talking to D2 TD5 Slabs

[Mjt084]

Had a chance to start working through the issues with my new Discon this weekend, got some rego-able tyres on it and started to look at the other faults.

Initially couldn’t get my Nanocom to talk to it but after noticing the cabin lights also weren’t working I changed fuse 20 and notice it also bought my radio, clock and diagnostic port back to life.

Plugged in the Nanocom, cleared the historic engine faults but couldn’t get it to read the SLABS ECU after multiple attempts… I’ve tried ignition in ACC, On and with the engine running and still nothing. Tried disconnecting the two plugs under the glovebox as has been suggested in other forums and still nothing… Any other suggestions? Does the SLABS ECU have its own fuse?

Thanks

[sierrafery]

Are the 3 amigos on ?

[Mjt084]

Are the 3 amigos on ?

No, just the warning/check engine light and ABS light.

[sierrafery]

If the 3 amigos are working on self test after ignition was turned on then only the ABS stays on alone and it doesnt go out while driving if a sensor fault was rectified i'd say that the SLABS ECU is very suspect, it's not about a fuse cos the blown fuse would bring on all the warnings not just the ABS light.