101RRS
10th April 2023, 07:37 PM
Its been a few years since I rebuilt my Hitachi air compressor and all has been good.
Until yesterday - started the car and got an orange suspension fault but the system still worked OK able to raise and lower with no cascading issues. As it was getting dark I left the issue and had a look this morning. The car had dropped to access height with the back passenger wheel on the bump stops. Hmmm [bigsad]
Putting the code reader on it I got C1A74 (Rear Left Sensor), C1A05 (Rear Left Height Sensor out of Range) - there were a few other error codes but mainly the sort you get when codes have not been cleared for a long while.
So it would seem the rear left height sensor was out of range and the system lowered it to where it thought it should be (on the stops) or there was a small hole, and then the system lowered the other three bags to try and match it.
After reading the codes, I cleared them started and rechecked - nothing came back and I have had not issues today.
Now I have had my car long enough to know that there types of faults are early warning of possible failing issues in the future so for what ever reason I may have height sensor on the way out - either sensor itself or the wiring to it.
I have not had to deal with these suspension issues before so I intend to get a new sensor in anticipation of it failing before too long.
Any tricks for new players on replacing these?
Thanks
Garry
Until yesterday - started the car and got an orange suspension fault but the system still worked OK able to raise and lower with no cascading issues. As it was getting dark I left the issue and had a look this morning. The car had dropped to access height with the back passenger wheel on the bump stops. Hmmm [bigsad]
Putting the code reader on it I got C1A74 (Rear Left Sensor), C1A05 (Rear Left Height Sensor out of Range) - there were a few other error codes but mainly the sort you get when codes have not been cleared for a long while.
So it would seem the rear left height sensor was out of range and the system lowered it to where it thought it should be (on the stops) or there was a small hole, and then the system lowered the other three bags to try and match it.
After reading the codes, I cleared them started and rechecked - nothing came back and I have had not issues today.
Now I have had my car long enough to know that there types of faults are early warning of possible failing issues in the future so for what ever reason I may have height sensor on the way out - either sensor itself or the wiring to it.
I have not had to deal with these suspension issues before so I intend to get a new sensor in anticipation of it failing before too long.
Any tricks for new players on replacing these?
Thanks
Garry