Running a cable from the roof to the rear boot section.

[Aussie Jeepster]

I want to run a cable from a panel on the roof to the inside of the car. The panel will be at the rear of the roof so a rear location is preferable to running down the side of the winscreen.
Does anyone have a parts diagram of what is under the rear panel??? It is held on with 4 clips which I'd like to replace when I take it off, so I'm also looking for part numbers for the clips.
Anyone have any clues?
I have a service manual but have been unable to find a parts listing.
Alan
185639

[p38arover]

I have a service manual but have been unable to find a parts listing.
Alan


See Search Genuine Land Rover Parts By Model | Jaguar Land Rover Classic Parts (https://parts.jaguarlandroverclassic.com/classic-land-rover-parts/)

[peterjj]

here's wots underneath the panel. Not much. Don't think there is room for a cable.
185645 185646
Though if coming from the roof, there is the hole for the sharkfin antenna. Mine just has a blanking plate bolted from underneath.
185644 It is less than an arms length from rear of the headliner. Put a hole in that then seal with lots of silicone. Then you can run underneath headliner and down inside pillar trims to wherever.

[Tombie]

Use the sharkfin point and a cable clam as per boats…