sunvisor part numbers D3

[PeterOZ]

ok folks,

D3 2007 SE
as I am getting new roof liner done I wanted to replace the sunvisors which have the cloth sagging and are quite daggy as you can imagine after 16 years of use.

Anyone have the part numbers for these?

thanks
cheers
Peter

[josh.huber]

I've had interior trimmers do them on customers cars and trucks before mate.

Edit- I'd go leather or pleather as it's easier to clean

[PeterOZ]

For anybody chasing these part numbers. 86.35 GBP each






EDQ500961LUM



EDQ500971LUM

[RANDLOVER]

Silly me, expected the visors and even the windscreen columns to be done as part of the headlining, when I had mine done, but mine don't look too bad as the new fabric is a close enough match, so the difference is not noticed at first glance.

[PeterOZ]

Silly me, expected the visors and even the windscreen columns to be done as part of the headlining, when I had mine done, but mine don't look too bad as the new fabric is a close enough match, so the difference is not noticed at first glance.

Pillars were done, I elected not to have visors done as I wanted to get originals, is that ok with you? [bigwhistle]

[PerthDisco]

As my roof and pillars steadily fall apart I’ve been wondering what to do with the visors. I’m quite partial to the LR pictures and data on the drivers side.

My plan is to remove all myself but will have to use a small trailer to get to the trim shop.

Was thinking to cut out the LR graphics and glue these over the retrimmed visors in same location. Guess the new ones will be about $400 once landed in Oz. About same as relining not including removal costs.

[PeterOZ]

As my roof and pillars steadily fall apart I’ve been wondering what to do with the visors. I’m quite partial to the LR pictures and data on the drivers side.

My plan is to remove all myself but will have to use a small trailer to get to the trim shop.

Was thinking to cut out the LR graphics and glue these over the retrimmed visors in same location. Guess the new ones will be about $400 once landed in Oz. About same as relining not including removal costs.

be prepared for a price shock. Visors are $315 each, clips are $115 each.

[PerthDisco]

Ex UK price was $115 referred above plus shipping etc so a good deal by sounds

[Airmech953]

Has anyone had any success with regluing the headliner/sunvisor fabric in situ, say by injecting glue under the fabric?

[PerthDisco]

Has anyone had any success with regluing the headliner/sunvisor fabric in situ, say by injecting glue under the fabric?

Mission Impossible I’d say as the liner includes the fabric and a foam backing which all needs to come off to properly fix. You could pull the fabric off and live with what’s behind it. You’d have to cut around all the fittings on the roof.

[BradC]

Has anyone had any success with regluing the headliner/sunvisor fabric in situ, say by injecting glue under the fabric?

It's not the glue that fails, it's the foam that disintegrates. In the Volvo community the "dodgy arse" fix was to use large head, short spike drawing pins (like those used to put paper on a pin up board). Those go through the material and into the back-board.

[PeterOZ]

Ex UK price was $115 referred above plus shipping etc so a good deal by sounds

better check your sums, that equates to $315 AUD each

[DiscoJeffster]

better check your sums, that equates to $315 AUD each

What exchange rate are you using ??

https://uploads.tapatalk-cdn.com/20230722/a09d8c5c402ffb82549c0e8ce3475f14.jpg

[PeterOZ]

What exchange rate are you using ??

https://uploads.tapatalk-cdn.com/20230722/a09d8c5c402ffb82549c0e8ce3475f14.jpg

it is still $315 AUD each . . . but hey spend your money and take your chances