Rear sway bar links Lemforder any good?

[Bohica]

Hello, I need a pair of the rear sway bar links. LR has only one in the country at $390.00. Are Lemforder any good? Lemforder look good after a search. Who is or was the OEM?
A slightly cheaper manufacturer is Meyle, who supplied parts to Tesla. Both of these are German companies.
I have a 50mm lift, do I buy longer ones? if so, what do I look for.
TIA

[AK83]

Lemforder and Meyle are both high quality manufacturers.
In some instances they are original makers of parts for D2s.

[Discodicky]

Lemforder is ZF

[Slunnie]

.

[Bohica]

No problem with the 50mm lift? Are there longer versions?
I am gobsmacked at the price between the OEM and LR.

[Dervish.]

I had stock lenght links in my TD5 with a 3" lift and ace.
No issues, but I only do very mild offroading, staying on roads in bad condition.

Put in the TF220 set, just as I was going to replace the old links anyways.
Partnumbers for the longer links, if You don't want to pay terrafirma extra,
are, as a Delphi brand, TC986 and TC1818.

Can't remember whuch is front and rear.
Stock vs the longer ones
https://i.imgur.com/NujDTd2.jpg
https://i.imgur.com/0R1iWAJ.jpg

Couldn't find the partnumbers when I was doing this so I resorted to the Terrafirma kit.

Can't see any reason to go for the genuine on these, even in stock lenght.

[Bohica]

The TC986 comes up as front for the D2 and the TC1818 comes up as the front for the D3/D4. Both are in the UK or USA, so I'll get the Lemforder ones.

[Kaaaiju]

Put d3 front links in the front and d2 front links in the back

[d2dave]

I have replaced the RH side one due to failure. I used a Meyle. So far so good. It survives a grueling crossing of the Simpson desert.

I have a 2 inch lift with ACE.

Bohica, do you have ACE?

[Bohica]

No ACE, just the manual SLS and 50mm spacers on the rear.
One day I will put in the SLS loom and the compressor. One day, just like Superfast Matt!
I put in the Meyle ones. I think that with the lift, the sway bar angles down a bit, but the anti sway aspect stays the same.
You need a 19mm spanner with these. Busy day today as I changed the LHS rear door lock actuator. Isn't that fun!