Discovery 2 CDL

[stuboy]

Need assistance in trying to locate issue with locking error signal. Nanacom is showing both drivers and passenger (all other 3) as open, only bonnet closed so therefore giving beep when either locking with remote or key. Seems BCM is not receiving the 2 separate door signals. After locking each door separately and finally drivers door with key. Left it a few days and it unlocked and then locked again with remote with no error, opened a door and error returned, that happened on 2 occassions but can’t get it to repeat something telling me it’s not the actuators. Also had a small leak passenger side corner of screen and so removed the trim to locate and repair leak, noticed drops of water on lower footwell connectors, so have had all apart sprayed with contact cleaner but no joy, also did same with BCM connectors

Any help would be appreciated, cheers Stu

[gromit]

Need assistance in trying to locate issue with locking error signal. Nanacom is showing both drivers and passenger (all other 3) as open, only bonnet closed so therefore giving beep when either locking with remote or key. Seems BCM is not receiving the 2 separate door signals. After locking each door separately and finally drivers door with key. Left it a few days and it unlocked and then locked again with remote with no error, opened a door and error returned, that happened on 2 occassions but can’t get it to repeat something telling me it’s not the actuators. Also had a small leak passenger side corner of screen and so removed the trim to locate and repair leak, noticed drops of water on lower footwell connectors, so have had all apart sprayed with contact cleaner but no joy, also did same with BCM connectors

Any help would be appreciated, cheers Stu

You're more likely to get an answer if you post this in the Discovery section rather than the Series II section.

Colin