Tins
8th October 2025, 08:31 AM
Nick's latest thread has for some reason morphed into a "printable" version. Not sure if that's me or the forum.
I want to add to Tombie's response, in that it's also important to not make the mistake that I did with my choice of printer. The FF CreatorPro 2 is a very capable, IDEX printer, but is terribly limited by a; print volume, and b; the terrible slicer it comes with. There are ways around the second bit, but not the first. So, my printer is a very expensive ornament, most of the time. I was fooled by the bling.
I want to add to Tombie's response, in that it's also important to not make the mistake that I did with my choice of printer. The FF CreatorPro 2 is a very capable, IDEX printer, but is terribly limited by a; print volume, and b; the terrible slicer it comes with. There are ways around the second bit, but not the first. So, my printer is a very expensive ornament, most of the time. I was fooled by the bling.