View Full Version : Inside diameter of County rear springs?
Bigbjorn
16th April 2007, 08:58 PM
I want to buy some new air bags from Truckspring, Los Angeles but they only list for Defenders. Does anyone know if the 110 County and Defender had the same i.d. rear springs?
lokka
16th April 2007, 09:13 PM
Yep the springs should be the same as there bigger in the rear than a rangie dont know the egzact id but the def and the county have the same rear spring seats in the chasis
sclarke
16th April 2007, 09:37 PM
Defender and County are also the same as Patrol springs in the Diameter
Utemad
17th April 2007, 08:14 AM
Do you have standard height springs?
I emailed them about the Disco airbags and they said they only do one bag design per vehicle so they only suit standard height vehicles.
Unless you could ask for same diameter but taller bags from a different vehicle I suppose.
Bigbjorn
17th April 2007, 08:27 AM
It has extended springs with a 2" lift but there are black plastic packers in above the bags to counter this.
Utemad
17th April 2007, 04:44 PM
That'll do it. I didn't think of that.
I might have to look into it again.
rar110
17th April 2007, 10:12 PM
The wire diameter of standard county rear springs are smaller than defender springs. From memory county is about 17 to 19 mm and defender is up to 21mm. I suppose this would affect the inner diameter of the coil.
sschmez
17th April 2007, 11:50 PM
Amazing what you find on the shoutbox
weeds (http://www.aulro.com/afvb/member.php?u=9768): hi
weeds (http://www.aulro.com/afvb/member.php?u=9768): can you do me a favour
weeds (http://www.aulro.com/afvb/member.php?u=9768): i cannot reply to posts at work
weeds (http://www.aulro.com/afvb/member.php?u=9768): a guy was asking the inside dia of 110 springs in the tech section
weeds (http://www.aulro.com/afvb/member.php?u=9768): i just measured an ARMY 110 and its 140mm
weeds (http://www.aulro.com/afvb/member.php?u=9768): you can even claim the post
weeds (http://www.aulro.com/afvb/member.php?u=9768): watch my typing i'm on my third rum
hiline (http://www.aulro.com/afvb/member.php?u=8869): no point measuring mine as its a 130
weeds (http://www.aulro.com/afvb/member.php?u=9768): i measured before i cracked the first rum
weeds (http://www.aulro.com/afvb/member.php?u=9768): i already have poyairs fitted so i could not measure
isuzu110
18th April 2007, 08:29 AM
I recently swapped my rear polyairs from my county to my defender. Yes the defender had a marginally thicker spring but the polyairs slipped in OK.
KhunMoo
22nd April 2007, 04:40 PM
I recently put a set of Defender rear coils in my County that had original softer springs to suit the load leveller. I have left the load leveller in place as it still seems to work and provides a bit of extra support when heavily loaded. The Defender springs gave me extra lift needed to support roof rack and 125lt replacement fuel tank. I then fitted a pair of 8mm spring packers from ARB to get just a tad more.
KhunMoo
Powered by vBulletin® Version 4.2.4 Copyright © 2026 vBulletin Solutions, Inc. All rights reserved.