Should i buy it?

[cycomick]

Hey All,

I have the opp to buy a series III running a ED33 3.3 Nissan Diesel with Cabstar 5spd box (Marks4wd Conversion).

It needs a new rear axle, has some rust in the doors and a few other spots including the very end of the chassis rails behind the back leaf mounts.

Also a full retrim and repaint are required as it's been sitting for 4 years in a paddock! Engine run's quite nicely and gearbox is nice and slick. I guess all the bushes and consumables would be knacked too..

Would this be considered a decent buy? Im concerned about getting parts such as rear axle asm and doors etc for this project...

Any advice would be great for this newbie!

Cheeers :D

[rangieman]

Hey All,

I have the opp to buy a series III running a ED33 3.3 Nissan Diesel with Cabstar 5spd box (Marks4wd Conversion).

It needs a new rear axle, has some rust in the doors and a few other spots including the very end of the chassis rails behind the back leaf mounts.

Also a full retrim and repaint are required as it's been sitting for 4 years in a paddock! Engine run's quite nicely and gearbox is nice and slick. I guess all the bushes and consumables would be knacked too..

Would this be considered a decent buy? Im concerned about getting parts such as rear axle asm and doors etc for this project...

Any advice would be great for this newbie!

Cheeers :D
If the price is right id go for it , the parts are very easy to get and not expensive at all :D

[cycomick]

Price will be around $400 i think... No Reg, No RWC - but engineered and registered with the conversion.

Thanks for the reply

Who is a good supplier of second hand parts for series vehicles in Melbourne?

Cheers

[rangieman]

Price will be around $400 i think... No Reg, No RWC - but engineered and registered with the conversion.

Thanks for the reply

Who is a good supplier of second hand parts for series vehicles in Melbourne?

Cheers
Grab it for that sort of $ try 4x4 in blackburn for parts new and used

[George130]

Most parts should be available.