PDA

View Full Version : Dedicated Pump bracket and power take off



RichardK
23rd December 2007, 10:03 PM
It has been some time in development but I have finally succeeded in developing a kit for mounting my dedicated hydraulic pump for my hydraulic winch and a power take off point for it.

The power take off is via v belt as there is little room available for a flat belt drive.

I will mount the pump in the next couple of days and connect the winch, I believe it could be a world first

Some pics.......



https://www.aulro.com/afvb/images/imported/2009/06/1393.jpg

The Complete Kit

https://www.aulro.com/afvb/images/imported/2009/06/1392.jpg

Platform in position


https://www.aulro.com/afvb/images/imported/2007/12/99.jpg


Drive take off

LandyAndy
25th December 2007, 09:23 PM
Not often I poke my nose in here,being a mere D2 and lower pilot:D:D:D:D:D:D:D:D
Richard you are a genius,I would be deleting the pics getting the bits fabricated professionally and tipping the vast returns into your retirement fund.
WELL DONE MATE!!!!!!
Andrew

RichardK
25th December 2007, 10:13 PM
Hello Andy, Merry Xmas mate.

They have been professionally made, laser cut, machine bent powder coated, unfortunately I don't see a fortune in it, too few hydraulic winches are in use in Oz and D3's would be a minute amount, I may be the only one. However the UK, Europe and the US may be different where the Milemarker is well accepted, I have already sent a kit off for evaluation to the UK and apart from some minor mods I think it should fill a gap for them.