GPS Laptop Mount

[Disco_owner]

check out this Blokes Laptop Cradle ;

he is a Woodworking teacher at TAFE

--------------

[101RRS]

You gave to be a member to view:(

[Disco_owner]

Alright Garry , should be able to see em now.

[rangieman]

Alright Garry , should be able to see em now.
No there not:eek:

[Disco_owner]

some more pics
-----
i have only a limit of 5

[Disco_owner]

and more pics
-------------

[HangOver]

wood in a car that's not trim, hmmm i dunno it just doesn't look right.
IMO

Nice n cheap though

[cucinadio]

wood in a car that's not trim, hmmm i dunno it just doesn't look right.
IMO

Nice n cheap though


well my wood trim n my Ls ls pretty nice :D

cheers

[HangOver]

well my wood trim n my Ls ls pretty nice :D
cheers

I'm not sure that came out right.............

I mean, if it's in a vehicle and part of the trim that's OK but otherwise looks a bit, well, naff.

It's OK for draws/barriers/liners etc but in the cab erghh

[Disco_owner]

Hangover

yeah you're right , it doesn't quite look Trim , I would personally prefer the Type where the laptop and cradle is above centre console

like the Ram-Mount , but as you mentioned the home made jobbie is cheap and affordable

not sure if you're seen this

[HangOver]

Hangover

yeah you're right , it doesn't quite look Trim , I would personally prefer the Type where the laptop and cradle is above centre console

like the Ram-Mount , but as you mentioned the home made jobbie is cheap and affordable

not sure if you're seen this

that looks good enough and substantial.
I have seen a simmilar-ish DIY job made with the seat post, (including quickrelease) from a push bike so the laptop could swivel and go up n down. It was weled onto the gearbox tunnel. Looked the part though and must have cost about $0 :D

[Disco_owner]

that looks good enough and substantial.
I have seen a simmilar-ish DIY job made with the seat post, (including quickrelease) from a push bike so the laptop could swivel and go up n down. It was weled onto the gearbox tunnel. Looked the part though and must have cost about $0 :D

do have any pics by any chance ?

[HangOver]

naaaa sorry, I cant even remember where I saw it.
I just saw it and though, good idea, I might do that for my LCD

It's hard to describe even, it was just the centre pole of a bike frame, (where the seat stem/pole pushes in) weled to a metal plate which was bolted to the tunnel.

[Disco_owner]

naaaa sorry, I cant even remember where I saw it.
I just saw it and though, good idea, I might do that for my LCD

It's hard to describe even, it was just the centre pole of a bike frame, (where the seat stem/pole pushes in) weled to a metal plate which was bolted to the tunnel.

got ya, i can sort of picture it.