Wiper Blades

[stevo68]

G'day all,

Any recommendations as to where you can get wiper blades for the D3, or is it only through a dealer as one of mine is just holding on at either end....luckily the left blade,

Regards

Stevo

[WhiteD3]

Recently got a pair of Aunger blade kits at Supercheap for $18(?) a pop.

You've got to buy the kit as the LR blade carrier will only take LR blades.

[stevo68]

Thanks Mark, went and had a look at the wiper blades on my car...now when you say "kit" what does that mean, is it the whole wiper section apart from the arm, ie the part that makes it go wipey wipe....side to side?? Just another example of Stevo the Clueless :angel:,

Regards

Stevo

[garryc]

G'day all,

Any recommendations as to where you can get wiper blades for the D3, or is it only through a dealer as one of mine is just holding on at either end....luckily the left blade,

Regards

Stevo
Get the Aunger 2 piece set 560mm. They mention Range Rover on the back of the packet. They supply a lot of different plastic clips to match the different vehicles. I got mine at Big W I think ;)

[WhiteD3]

Stevo,

It's the rubber blade and the fitting that holds the blade. This then clips into the arm attached to the motor. Found this on the work bench.

Note to self: Clean up garage more often:angel:

https://www.aulro.com/afvb/ (http://imageshack.us)

[Searover]

G'day all,

Any recommendations as to where you can get wiper blades for the D3, or is it only through a dealer as one of mine is just holding on at either end....luckily the left blade,

Regards

Stevo

I bought genuine LR ones $17.89 each inc GST, Part # DKC500150

Cheers

[300+]

The genuine ones are not that expensive. I had mine changed yesterday at the service. The genuine blades are a special design to handle the curved screen - so they said. The new blades also don't judder the way the old ones did either.

Cheers, Steve

[Scouse]

I bought genuine LR ones $17.89 each inc GST, Part # DKC500150

CheersUnfortunately that part number has now superceded to DKC500230 & they're about 3 times the price :mad:.

[Searover]

Unfortunately that part number has now superceded to DKC500230 & they're about 3 times the price :mad:.

So Scouse I've been sold old stock:mad:, is there any difference in quality?

Thanks

[CaverD3]

The new ones actually work. Dealer replaced mine and now...............silence.:D
LR have solved the problem with the wipers but want to charge you for it.:mad:

[WhiteD3]

Stevo,

It's the rubber blade and the fitting that holds the blade. This then clips into the arm attached to the motor. Found this on the work bench.

Note to self: Clean up garage more often:angel:

http://img132.imageshack.us/img132/7687/wipers1qd2.jpg (http://imageshack.us)

Now juddering again:(

[tonyt]

Now juddering again:(

repco has a wiper that fits the d3s but its 28 dollars good quality though