Wiring, D3 bumper mounted fog lights

[rovers1952]

Have arranged fittment of ARB Bull Bar. Like the steering wheel mounted radio buttons, Was wondering if fog light wiring is in place behind bumper of my TDV6S If so thought I could purchase the lights to be fitted to the Bar rather than the blanking plates. Anyone have any thoughts?

[Tote]

If you went the factory wiring route you would need the headlight switch that pulls out two positions to activate front and rear fog lights as well, don't know if the S has this.
Regards,
Tote

[rovers1952]

thanks & yep....headlight switch is configured as described....presume it is wired at that end!!

[sniegy]

Hi Rovers1952,
Just want to check the head light switch again. Are u sure it pulls out "2" positions & not 1. All the "S" models i have seen the switch only pulls out 1 position. Therefore u would need to replace the switch with an SE variant & reconfigure vehicle with front fog lights.:)

[rovers1952]

H'mmmm....I checked again....yup....only pulls out one position to activate the rear so called bad weather lights. Seems silly to not have the front & rear in the same circuit. Presumably the wiring provision is in place.

[sniegy]

The part number for this component is YUD501480PVJ
I had a play this morning & plugged an SE variant in & it all worked. But remember the wiring loom only goes to behind the R/H/F headlight, so the rest that sits in between the bumper u will have to make up yourself.

Cost of switch pack is approx $110.00 incl GST.

[rovers1952]

most usefull Sneigy. Am getting a spare spare wheel & tyre from a recycler in Adelaide. They seem to get the desert rollovers. Will try them for lights & switch. Many thanks