transfer case

[LRO]

Hi
Need some advice on why, when I select low range centre diff lock in my 1987 County that only one front wheel will spin and none at the back will turn. The light on the dash does not come on, (never did since I have had it.)

[Red Rocket]

The answer to that is very simple......The diff lock is not being engaged!
Red Rocket.

[LRO]

Hi
I gathered that, any ideas why. what should i bee looking for

[Bearman]

Hi LRO, Most likely it is a vacuum actuator problem. Either one of your vacuum lines has come adrift (unlikely) or else the rubber diaphragm in the actuator is stuffed (likely). Check if the actuator is working. Regards....Bearman

[rovercare]

Hi LRO, Most likely it is a vacuum actuator problem. Either one of your vacuum lines has come adrift (unlikely) or else the rubber diaphragm in the actuator is stuffed (likely). Check if the actuator is working. Regards....Bearman

87 Brian, I'm guessing LT230:)

Which means pokeing the head under and seeing if all the actuating levers are operateing the swivel tang on the nose of the case, if thats the case:(

[Bearman]

LRO, disregard my comment - wrong box. Matt, you are spot one, memory lapse on my part. CRAFT setting in. Thanks....Bearman

[rovercare]

LRO, disregard my comment - wrong box. Matt, you are spot one, memory lapse on my part. CRAFT setting in. Thanks....Bearman

Still a worthwhile post, it may of been changed out for LT95, or may help someone searching:)

[LRO]

Hi
Thanks for that, turned out to be the pin was missing out of the lever, so when i went to shift into cdl low the bigger pin would move but the lever stayed where it was. all fixed now. It is a lt230