skaufman
25th February 2009, 08:11 PM
Following an unplanned swim in a local creek the gearbox went into limp home mode. After replacing the Electronic Automatic Transmission ECU, flushing the XYZ and gear position switches, cleaning the air flow meter my gearchanges are still having big issues.
Basically the gearbox is not wanting to change up a gear. When accellerating hard (or just pulling away from a stop) the gearbox stays in first gear until I back off on the throttle and then accelerate again to allow it to change to the next gear. It is then ok in 2nd and 3rd but does not like going into 4th.
When on cruise control at 100km/h it hunts between 3rd and 4th (3500 revs to 2500revs) when there is any type of hill.
If I don't ease off on the throttle it does not change gear.
The only thing that I can think of that I have not done yet is change the auto transsmission fluid.
Anyone have any other ideas?
Finally I am nowhere near civilisation and the local mechanical services are not familiar with Discoveries. (1500km to Perth).
Your assistance is much appreciated.
Basically the gearbox is not wanting to change up a gear. When accellerating hard (or just pulling away from a stop) the gearbox stays in first gear until I back off on the throttle and then accelerate again to allow it to change to the next gear. It is then ok in 2nd and 3rd but does not like going into 4th.
When on cruise control at 100km/h it hunts between 3rd and 4th (3500 revs to 2500revs) when there is any type of hill.
If I don't ease off on the throttle it does not change gear.
The only thing that I can think of that I have not done yet is change the auto transsmission fluid.
Anyone have any other ideas?
Finally I am nowhere near civilisation and the local mechanical services are not familiar with Discoveries. (1500km to Perth).
Your assistance is much appreciated.