D2 Rear Bumper

[AussieAub]

Hail all the Guru's! :D
I have to remove the rear bumper on the Disco.
Looking at RAVE there appears to be only 2 bolts holding it on.
Is that correct, or am I missing something?

When I've finished fixing it, how important is it to "tighten bolts securing rear bumper to chassis to 45Nm (33lbf.ft)"?

Bearing in mind I have no torque wrench, will "FT" do?
Or should I really be looking to get a torque wrench before attempting the job?

Cheers,

..:: KIEREN ::..
2000 Disco II Auto V8
Object Of Mass Consumption
AussieAubs Disco Page (http://aussieaub.blogspot.com)

[Tombie]

Your right...

And just tighten then 'nip' up will be fine.

[Slunnie]

Dont forget to unplug the lights behind each cluster.

[Rosscoe68]

yes, only 2 bolts, and its a plastic reinforcement, so i guess not too tight ?

[scarry]

Dont forget to unplug the lights behind each cluster.

And when you clip the lights back in,smear a bit of silicon sealent around them,it will stop them falling out next time you go down a corrugated road.;)

[AussieAub]

Cheers guys! :D :D

..:: KIEREN ::..
2000 Disco II Auto V8
Object Of Mass Consumption
AussieAubs Disco Page (http://aussieaub.blogspot.com)