Australian Land Rover Owners

Section Widget
Travel

Overseas

Overseas

Technical
Categories Widget (Show All)
Recent Articles

derby 1

There is no available content written by derby 1

Recent Article Comments Widget
Recent Blog Posts
Recent Forum Posts

Correct Procedure to Fit Exhaust Manifold/Turbo Studs?

How easy/hard are the exhaust manifold studs to remove later if needed? Do you have to heat them up?
Max Headroom 2.3m 5th April 2026, 02:14 AM

Correct Procedure to Fit Exhaust Manifold/Turbo Studs?

If the studs dont have a listed spec, use the torque for the nuts using either the double nut or a stud setting tool.

in the real world...
Blknight.aus 5th April 2026, 01:03 AM

Correct Procedure to Fit Exhaust Manifold/Turbo Studs?

Be careful using anti-seize on nuts. This will change the nut factor ('K' factor) of the torque specification. The specified torque of 25Nm was predicated
Max Headroom 2.3m 4th April 2026, 11:59 PM

Novice towing question

To possibly answer my own question: I can see a 12-pin connector next to the receiver. It seems to have a harness running to it. Am I good here? Should
WhatIsClocks 4th April 2026, 11:50 PM

Fuel pressure errors

Ignore everything else in this thread because the HPFP bears zero resemblance to the 2.7 which was in discussion.
BradC 4th April 2026, 11:38 PM

Search AULRO.com ONLY!	Search All the Web!

All times are GMT +10. The time now is 03:09 AM.

AULRO.com
Copyright 2001 - 2026
Independently Owned and Operated by
Dave Blears Computing - DavecandoIT - AULRO.com
LAND ROVER and its logo are the registered trademarks of Land Rover.
Land Rover is not affiliated with AULRO.com.

Section Widget

Categories Widget (Show All)

Recent Articles

derby 1

Recent Article Comments Widget

Recent Blog Posts

Recent Forum Posts

Correct Procedure to Fit Exhaust Manifold/Turbo Studs?

Correct Procedure to Fit Exhaust Manifold/Turbo Studs?

Correct Procedure to Fit Exhaust Manifold/Turbo Studs?

Novice towing question

Fuel pressure errors