Australian Land Rover Owners

Section Widget
Travel

Overseas

Overseas

Technical
Categories Widget (Show All)
Recent Articles

kookynet

There is no available content written by kookynet

Recent Article Comments Widget
Recent Blog Posts
Recent Forum Posts

Correct Procedure to Fit Exhaust Manifold/Turbo Studs?

How easy/hard are the exhaust manifold studs to remove later if needed? Do you have to heat them up?
Max Headroom 2.3m 5th April 2026, 01:14 AM

Correct Procedure to Fit Exhaust Manifold/Turbo Studs?

If the studs dont have a listed spec, use the torque for the nuts using either the double nut or a stud setting tool.

in the real world...
Blknight.aus 5th April 2026, 12:03 AM

Correct Procedure to Fit Exhaust Manifold/Turbo Studs?

Be careful using anti-seize on nuts. This will change the nut factor ('K' factor) of the torque specification. The specified torque of 25Nm was predicated
Max Headroom 2.3m 4th April 2026, 10:59 PM

Novice towing question

To possibly answer my own question: I can see a 12-pin connector next to the receiver. It seems to have a harness running to it. Am I good here? Should
WhatIsClocks 4th April 2026, 10:50 PM

Fuel pressure errors

Ignore everything else in this thread because the HPFP bears zero resemblance to the 2.7 which was in discussion.
BradC 4th April 2026, 10:38 PM

Search AULRO.com ONLY!	Search All the Web!

All times are GMT +10. The time now is 01:34 AM.

AULRO.com
Copyright 2001 - 2026
Independently Owned and Operated by
Dave Blears Computing - DavecandoIT - AULRO.com
LAND ROVER and its logo are the registered trademarks of Land Rover.
Land Rover is not affiliated with AULRO.com.

Section Widget

Categories Widget (Show All)

Recent Articles

kookynet

Recent Article Comments Widget

Recent Blog Posts

Recent Forum Posts

Correct Procedure to Fit Exhaust Manifold/Turbo Studs?

Correct Procedure to Fit Exhaust Manifold/Turbo Studs?

Correct Procedure to Fit Exhaust Manifold/Turbo Studs?

Novice towing question

Fuel pressure errors