Page 3 of 3 FirstFirst 123
Results 21 to 23 of 23

Thread: Power Steering Pump - cactus!

  1. 12th November 2012, 08:09 PM #21
    bee utey's Avatar
    bee utey
    bee utey is offline AT REST
    Join Date
    Apr 2009
    Location
    Crafers West South Australia
    Posts
    11,732
    Total Downloaded
    0
    Bigdog, I doubt if the bolt-on pulley with or without pump will be suitable. I suggest you contact a specialist LR wrecker and purchase a correct pulley. Postage would not be dear even from WA. Linn Rover springs to mind, I've bought a few bits off them.
    Reply With Quote Reply With Quote
  2. 28th November 2012, 11:57 AM #22
    bigdog's Avatar
    bigdog
    bigdog is offline Master
    Join Date
    Jun 2006
    Posts
    265
    Total Downloaded
    0
    Done

    Second hand pulley from WA arrived in a couple of days.
    Needed to remove the Dizzy, to adjust the power steering pump, to refit the pulley and belt?????? A surprise but it gave me a chance to redo the timing.

    So does anyone have any tips on the belt tension? I have approx 7-8mm up/down movement on each belt at the halfway point between pulleys?

    And would the preference be to err on the side of slightly loose, or slightly tight (just right would be good)?
    Reply With Quote Reply With Quote
  3. 28th November 2012, 03:38 PM #23
    bee utey's Avatar
    bee utey
    bee utey is offline AT REST
    Join Date
    Apr 2009
    Location
    Crafers West South Australia
    Posts
    11,732
    Total Downloaded
    0
    If, when you pull full lock, and/or flick on all the spot lights, you get a belt squawking noise and the tacho needle drops, you know it's too loose.
    Reply With Quote Reply With Quote
Page 3 of 3 FirstFirst 123
« Changing swivel hub oil | 89 rangie / toughdogs »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!