Printable View
Yikes! So it's only on there for the noise. Yes, I can see you'll have to experiment a bit. I wonder what anyone else has done?
Below is a photo from somebody on here, though I can't remember who or from what thread I pinched this. It just shows how he managed to run two snorkels into the one intake.
errr... well thats one way to go about it :) lolQuote:
Originally Posted by Davo
I do wonder how well it worked . . .
So while a D1 winch bar fits on the rails... it dont fit around the guards :( [bigsad]:cry:
anyone know where a RRC winch bar might be hiding away?
Attachment 129622
You need to trim the sides a little (the top and bottom surfaces ... the side stays)and it fits ... the D1 bar is more pedestrian friendly with the set back top bar.
That's getting my vote for Top Tip today . . . now to find a Disco bar . . .
Hi ya, well I have looked at this... I'll need to cut a fair bit off the wings length wise and also on the inside just like you say... but I am not sure if I should do then as I wont be able to put the bends back in to the sides for strength.Quote:
Originally Posted by rrturboD
Also not sure what I should use to cut apart from angle grinder with a cutting disc.
Yep, I've got one on roids with a Warn and synthetic. Surplus to requirements.Quote:
Originally Posted by RaZz0R
PM me a mob or email and I'll send you some pics.
cheers, DL
Details sent ;)Quote:
Originally Posted by 350RRC
That would be awesome - as I think this bar would be great on a D1 and I don't think it deserves to be cut up.
Cheers in advance!
Pics sent via email.
cheers, DL
