Lt 95 gearbox problem HELP!

Can I buy the fairy overdrive[emoji3]?

Quote:

---

Originally Posted by Bearman

And don't forget to loctite the sleeve and gear onto the shaft when you do it otherwise you will have oil transfer from the transfer case into the gearbox and the output gear will wear on the mainshaft splines.

---

Hmm im not sure what you mean exactly, do i have to put some loctite/sealant on the outer face of the sleeve that goes into det oil seal? Then i put som loctite/sealant to the splines that holding the transfer gear? .. karl.

Quote:

---

Originally Posted by Blue sweden

Hmm im not sure what you mean exactly, do i have to put some loctite/sealant on the outer face of the sleeve that goes into det oil seal? Then i put som loctite/sealant to the splines that holding the transfer gear? .. karl.

---

Yes Karl. That is sort of correct. Loctite under the sleeve where it sits on the mainshaft and on the splines of the gear and mainshaft.

Quote:

---

Originally Posted by Bearman

Yes Karl. That is sort of correct. Loctite under the sleeve where it sits on the mainshaft and on the splines of the gear and mainshaft.

---

Hi again mate☺. If i understand you correctly , do i have to put sealant inside the sleeve too? But the mainshaft is rotating and the sleeve is not. or is it another sleeve that i can not see? .. karl

Quote:

---

Originally Posted by Blue sweden

Hi again mate☺. If i understand you correctly , do i have to put sealant inside the sleeve too? But the mainshaft is rotating and the sleeve is not. or is it another sleeve that i can not see? .. karl

---

Yes Karl, under the sleeve - it must rotate with the mainshaft or it will leak oil into the gearbox.

Quote:

---

Originally Posted by Bearman

Yes Karl, under the sleeve - it must rotate with the mainshaft or it will leak oil into the gearbox.

---

Ahaaa! Thank you bearman. now i understand😀. I tried yesterday to pull and push and rotate the mainshaft without any progress. 2 hours of hard work. I will try today too. ..karl.

Try pulling on it, rotate 180 degrees while holding the pressure on it and then let it move forward a little.

Quote:

---

Originally Posted by Bearman

Try pulling on it, rotate 180 degrees while holding the pressure on it and then let it move forward a little.

---

Ok. Will try that. Thanks bearman.

You're not holding your tongue the right way... 😁

Best of luck.

Quote:

---

Originally Posted by Meccles

Can I buy the fairy overdrive[emoji3]?

---

Na. I think i will keep it. Maybe😊