4.4 Starter Motor

Quote:

---

Originally Posted by Rangier Rover

Some one will have to make one for you. Where are you located?

If you cant get one I can make one for you next time I'm at the lathe.
I make them a heat shrink fit so it stays on the starter.
Tony

---

Im in Preston, north area of Melbourne. what would you charge me? do u have to heat shrink it to the starter?

Cheers,
Troy

Quote:

---

Originally Posted by GuyG

<snip> .... a possible issue with fitting a P76 starter is that the front driveshaft and the starter solenoid can make contact breaking the casting. ... <snip>

---

A long time ago this part of the thread, however.

If there is a problem in how close a 4.4 starter gets to the front driveshaft on a RRc. Source a front driveshaft off a 1985 Torqueflyte-727 auto, they were a solid bar instead of a steel tube and therefore you get a little more clearance between the shaft and the starter.

Diana

This place is the go:
Hi Torque Starters

Made for the p76, also solenoid location can be rotated 360 degrees

thought I'd share. I only stumbled upon the website. google only brought me to this thread.

also I found Land Rover Parts - Home helpful with my p76engine rebuild. Valley gasket, bearings, seals etc that I couldn't get from local parts shops.