Page 3 of 3 FirstFirst 123
Results 21 to 23 of 23

Thread: 4.4 Starter Motor

  1. 16th April 2009, 05:39 PM #21
    maxpower
    maxpower is offline Fossicker
    Join Date
    May 2008
    Location
    melbourne, aust.
    Posts
    29
    Total Downloaded
    0
    Quote Originally Posted by Rangier Rover View Post
    Some one will have to make one for you. Where are you located?

    If you cant get one I can make one for you next time I'm at the lathe.
    I make them a heat shrink fit so it stays on the starter.
    Tony
    Im in Preston, north area of Melbourne. what would you charge me? do u have to heat shrink it to the starter?

    Cheers,
    Troy
    Reply With Quote Reply With Quote
  2. 16th April 2009, 06:24 PM #22
    Lotz-A-Landies's Avatar
    Lotz-A-Landies
    Lotz-A-Landies is offline Super Moderator Gold Subscriber
    Join Date
    Jul 2006
    Location
    East-South-East Girt-By-Sea
    Posts
    17,665
    Total Downloaded
    1.20 MB
    Quote Originally Posted by GuyG View Post
    <snip> .... a possible issue with fitting a P76 starter is that the front driveshaft and the starter solenoid can make contact breaking the casting. ... <snip>
    A long time ago this part of the thread, however.

    If there is a problem in how close a 4.4 starter gets to the front driveshaft on a RRc. Source a front driveshaft off a 1985 Torqueflyte-727 auto, they were a solid bar instead of a steel tube and therefore you get a little more clearance between the shaft and the starter.

    Diana

    You won't find me on: faceplant; Scipe; Infragam; LumpedIn; ShapCnat or Twitting. I'm just not that interesting.
    Reply With Quote Reply With Quote
  3. 20th June 2012, 03:17 PM #23
    wevets Guest

    p76 engine bits

    This place is the go:
    Hi Torque Starters

    Made for the p76, also solenoid location can be rotated 360 degrees

    thought I'd share. I only stumbled upon the website. google only brought me to this thread.

    also I found Land Rover Parts - Home helpful with my p76engine rebuild. Valley gasket, bearings, seals etc that I couldn't get from local parts shops.
    Reply With Quote Reply With Quote
Page 3 of 3 FirstFirst 123
« Dumping fuel into LH bank | 1 litre of coolant a week »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!