Hi
Have not used that software in a long long time ....
First thing to do is:
1. Turn it off.
2. Discharge your static and hold onto something earthy or wear a static strap.
3. Remove and reseat all 4 RAM chips in the same sockets.
4. Turn it back on again and redo the test.
If it was a RAM chip badly seated the problem will go away.
If not repeat the above but swap over some chips to another slot and see if the memory fault occurs at a different location. The mem tester should tell you at what location a failure occurred at. If the fault moves with the chip then bingo - problem found.
You could also possibly reseat the CPU itself.
Mike
Our car: Fuji White MY13 D4 SDV6 SE 3.0 Litre, 8 spd auto.
My car: Series 2a Workshop, 109 inch WB, ex mil., 1971. To be restored.
Wife's car: Series 2a FFT, LWB, ex. mil., 1966. To be restored.
Bookmarks