-
23rd September 2012, 05:14 PM
#1
no pressure in rail discovery 1 1999
no pressure at rail have checked relays and fuses just turned the car off then it wouldn't start have reset inertia sensor fuel pump still not switching on is there any thing else i could check before removing fuel pump
-
23rd September 2012, 05:38 PM
#2
Check for power at the fuel pump connector.
-
23rd September 2012, 05:49 PM
#3
I have come across a faulty fuel pump relay in a TD5 Defender. D2s and Defenders use similar relays. Pull the relay out of its socket and replace it, shortly after you turn on the ignition (the fuel pump relay times out after about 1/2 minute) to see if it is activating. Swap it with a similar relay next.
Erich
-
23rd September 2012, 06:07 PM
#4
+1 for BigJon's suggestion, use a test light plugged into the 2 fatter power wires. Crank engine for 1 second or so.
If there's power at the plug then kick the fuel tank, a faulty pump will sometimes restart with a shock.
If there's no power at the plug look at the connector over the muffler, check for darkened plastic around the pins (applies to pump plug too) then check the fuel pump relay is 1. clicking, 2. has power in at pin 30, 3. has power out at pin 87 during cranking.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Search AULRO.com ONLY!
|
Search All the Web!
|
Bookmarks