Results 1 to 3 of 3

Thread: Diff housing

  1. 10th October 2014, 10:08 PM #1
    Kevin B's Avatar
    Kevin B
    Kevin B is offline Master
    Join Date
    Jan 2013
    Location
    Penrith
    Posts
    922
    Total Downloaded
    0

    Diff housing

    Hey all well I been looking over this diff housing I picked up and I did notice when I got it that it has taken a rather hard knock on the front, the guy I got it off said his missus hit a stump in the grass and he pulled it apart the check the crown wheel wasn't rubbing and said it was fine, but my question is would a knock hard enough to put a dent shown in the picture v bee enough to bend the housing it looks straight but I dont have another to compare it to

    1412942859297.jpg

    1412942899811.jpg
    Reply With Quote Reply With Quote
  2. 10th October 2014, 11:16 PM #2
    Kevin B's Avatar
    Kevin B
    Kevin B is offline Master
    Join Date
    Jan 2013
    Location
    Penrith
    Posts
    922
    Total Downloaded
    0
    Thats what I thought too, always goodcto get a second opinion, also ill be striping the Center out to check it out, thinks its eirth bashing the dent out from inside while I can get to it
    Reply With Quote Reply With Quote
  3. 11th October 2014, 01:09 PM #3
    Tank's Avatar
    Tank
    Tank is offline AT REST
    Join Date
    Jan 1970
    Location
    Moruya Heads/Sth. Coast, NSW
    Posts
    6,532
    Total Downloaded
    0
    When you pull the diff centre out, lay a long straight edge across the centre mating surface and measure, either by eye or tape measure the same point on both sides, Regards Frank.
    Reply With Quote Reply With Quote
« What next? | mystery warning light »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!