Nice work Rick.
I finished off the carrier bar.
I'm leaving the latch as is for now, will see how it fares.
Sent from my GT-S7562L using AULRO mobile app
Tackled something I had very little chance of driving, so gave the winch its 1st run actually recovering myself! Also done some 'adjustments' to the RH rear 1/4 and rear bumper at the same time...![]()
Nice work Rick.
I finished off the carrier bar.
I'm leaving the latch as is for now, will see how it fares.
Sent from my GT-S7562L using AULRO mobile app
Premier 9000lb and yes it went well. Required snatch block and pulling with the 1st layer on the drum tho. Ledge was vertical with exposed roots.
Did an oil and filter change![]()
2006 TDV6 Disco
Replaced starter motor. Twice.. 2nd hand unit that was working a few weeks earlier decided solenoid would stick so replaced with new unit. Also replaced starter positive and earth leads with 0 b&s cable.
Fitted extra temp gauge and engine saver
Regreased and adjusted the wheel bearings, then this arvo after my late lunch I have to flush the brake fluid. All in prep for my high country trip over xmas/new year
Neale
85 Range Rover Ute (Project in pieces)
89 Range Rover Classic (Black Thunder)
93 200tdi Disco,(OGRE)
96 300tdi Disco, DEAD MOTOR
04 Nissan Patrol with ALL the fruit
09 Cub Daintree Kamperoo
12 VE II Commodore Ute DD
Auto trans service yesterday and fitted temp gauge to trans. All set for Xmas getaway out west
Fitted a new serpentine belt and auto adjuster as well as a full set of coolant hoses.
Cleaned out the back (man I had some junk in there) ready for packing for holidays.
Neale
85 Range Rover Ute (Project in pieces)
89 Range Rover Classic (Black Thunder)
93 200tdi Disco,(OGRE)
96 300tdi Disco, DEAD MOTOR
04 Nissan Patrol with ALL the fruit
09 Cub Daintree Kamperoo
12 VE II Commodore Ute DD
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Bookmarks