Just received my new viscous fan clutch from Roverlord.
Thanx for the excellent service Heather & Mario.
Dave
Why would they failI have 40year old cars running there original electric fans. Way more reliable than a clutch fan that can give up the ghost at any time with no warning
Original temp switches to run the fans, original wiring. The relays that drive the fans can get crispy plugs onto the relays. That is the only real issue I've had in decades.
seeya,
Shane L.
Proper cars--
'92 Range Rover 3.8V8 ... 5spd manual
'85 Series II CX2500 GTi Turbo I :burnrubber:
'63 ID19 x 2 :wheelchair:
'72 DS21 ie 5spd pallas
Modern Junk:
'07 Poogoe 407 HDi 6spd manual :zzz:
'11 Poogoe RCZ HDI 6spd manual
Just received my new viscous fan clutch from Roverlord.
Thanx for the excellent service Heather & Mario.
Dave
Actually, you are quite right. The first thing I do to any car that comes to this house is remove and snip out all added wiring. If it's something that needs to stay, I unwrap every bit of insulation tape and pull of any aftermarket split harness. I almost always find ****ty crimp on terminals (that readily fall off with the gentlest of touches) or bare wires twisted together.
I seem to go through a heck of a lot of solder and heatshrink whenever a new car comes into this house
seeya,
Shane L.
Proper cars--
'92 Range Rover 3.8V8 ... 5spd manual
'85 Series II CX2500 GTi Turbo I :burnrubber:
'63 ID19 x 2 :wheelchair:
'72 DS21 ie 5spd pallas
Modern Junk:
'07 Poogoe 407 HDi 6spd manual :zzz:
'11 Poogoe RCZ HDI 6spd manual
Fitted the new viscous coupling just now and noticed a lot more air than my modified one straight away, and it disengaged after a short time where as my old one didnt at all so will take it for a run later today after the weather warms up a bit. Expecting 38 deg today so that will give it a nice test. We have a 3 k long hill close by so with AC on it should let me know if that was my heating issue.
Dave
dont forget that the factory gauge is slow to react. by the time you see it over half way it can be too late. keep a very close eye on it and if it climbs at all back off and let it cool down. or else you will be needing a lot more than a new viscous fan.
mine had to be nursed constantly on highways fully loaded. im surprised it stayed cool actually when you saw how blocked my radiator was and how bad my cooling system was. but i watch gauges like a hawk. aviation history.
maybe check the rest of your system too. mine looked very clean from the outside but the inside was a different story.
Fausto79 ya might have missed an earlier post. But yep my rad is a lil sad in the fin department, I wouldnt go too close with a high pressure washer. But thats going to have to wait till I get back. Its all still there but a bit fragile.
Max temp I saw was 93. Big improvement in max temp as well as the time it takes to come back to 82, running temp once I reached the top.
So far so good. The real test will be the trip to Lake Gairdner with my bike and camping gear in the van and the Disco pretty well loaded with tools, spares and fuel. Oh and quite a bit of beer.
Dave
I too agree re reliability of electric motors.
As a matter of interest.
I had - dare I say it (Pajero) a few years back - v6 petrol. It decided it didnt like the crank bolt anymore so it spat it out in two pieces north of Woomera in SA. Thankfully the water pump didnt run off the crank pulley, but the alternator did, so I had no power to the battery (only one). I managed to drive all the way back to Adelaide, was near about 550km with no alternator....but the battery was close to dead. No cooling fan either so temps went up a little at lights.
The point here is that less electrical gear running gave me more kms, as I all I really needed was the fuel pump and computer. If the vehicle can run without electric fans then probably not an issue, but if you find yourself with a dead alternator or electrical charging problem and you require electric fans to get over the ensuing hills you may be in trouble, hence where a mechanical fan has its advantages. I think the greatest downside to viscous fans is actually knowing if they are working properly otherwise they are simple and reliable.
Until you snap a fan/serpentine drive belt and don't have a spare on hand.....
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Bookmarks