Results 1 to 3 of 3

Thread: Taipan exhaust

  1. 28th June 2011, 07:26 PM #1
    robbotd5's Avatar
    robbotd5
    robbotd5 is offline Wizard
    Join Date
    Jul 2009
    Location
    Lake Macquarie NSW
    Posts
    1,353
    Total Downloaded
    0

    Taipan exhaust

    Gday all.
    Anyone fitted a Taipan exhaust system to a TD5? Thinking of fitting one to my 04 D2a TD5 classic manual. Along with a few other little engine ECU mods.
    Regards
    Robbo.
    Reply With Quote Reply With Quote
  2. 28th June 2011, 07:47 PM #2
    twr7cx
    twr7cx is offline YarnMaster Supporter
    Join Date
    Feb 2011
    Location
    Hobart, Tasmania, Australia
    Posts
    3,828
    Total Downloaded
    0
    I have never seen or heard of them, but looking at their website I can't say I'm impressed - Landrover TD5 Discovery 2001-2004 - Performance that Bites - in the FAQ section, they have their philosophy on why 3" exhaust, they pretty much say they don't do any real R&D on the particular vehicle and engine combo, but rather use the same sizing for ALL vehicles, regardless of engine size.

    Now I'm not saying that 3" isn't a good size for it, they might have got lucky, but there might also be better setups too, which would be found is some testing was done.

    I'd do a search. 2.5" seems to be a size that a lot of people have stuck with and remained happy. Just needs to have the factory restrictive cans replaced. You'd probably also be able to build a custom system for cheaper than a lot of these performance companies sell there off the shelf setups for.
    Reply With Quote Reply With Quote
  3. 28th June 2011, 09:17 PM #3
    johncat07
    johncat07 is offline Fossicker
    Join Date
    Jul 2010
    Location
    tully
    Posts
    17
    Total Downloaded
    0
    i seen a bit on the telly where a 4.2 patrol had a system fitted. they dynoed the vechile before and after with 20hp gain. the reason for the 3 inch exhaust is the drop in exhaust temps, below the factory set figure. then when they "tune" up the vechile the exhaust temp rises, but because they run the 3 inch system to drop the temp you end up with your factory exhaust temp again. why? because chipping a vechile and going above the factory temp will shorten the life of your engine and could do damage the valve's.not sure on td5 but most vehicle engines have a restrictive dump pipe off the turbo, often a larger one of these bolted in and a free flowing cat inverter will lower your exhaust temps, any decent exhaust shop should be able to make your current system work at a fraction of what a taipan system costs. then you can chip it.
    Reply With Quote Reply With Quote
« Unusual Vibration Td5 | Retrofitting Volumetric Sensors - am I missing something »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!