TD5 Starter rebuild

Quote:

Originally Posted by mturri

It is worth doing some continuity tests with a multimeter or tester as to make sure everything stayed as it should be. In the above picture:

- The left hand contact is common to ground so should have continuity against the housing.
- The right hand contact should only conduct to the external contact bolt where the battery positive connects.
- The external Lucar connector (spade) should only conduct to the lower right end conductor going down into the solenoid coil.

Finally push the new plunger (with old spring) in and reinstall the housing cover plate. Starter is now as good as new!

Cheers
Matt

Hey Matt, thank you so much for the excellent pictorial instructions. I just completed the repair and for $29.95 and a few hours work it was a cheap fix. That top bolt is a challenge!

I also went through the continuity checks and have a question/comment. For the third test on the Lucar connector for the solenoid, I also found this has continuity with the housing and ground. It made me scratch my head a bit until I realised the solenoid won't work without a connection to ground. It's not a dead short as the coil provides resistance in the circuit.

Thanks again!