-
16th January 2012, 10:58 PM
#1
Taking D2a headlights apart
Has anyone done this - I'm looking to take the perspex covers off a set and place them on the set already in the vehicle as they are yellowing/stone chipped. The donor set have had the wiring altered and the some chopping on the mounting holes as they came off a facelift project, hence the reason for just swapping the covers.
Is the front stuck on or just held in place with the tabs?
Cheers
Rich
-
17th January 2012, 10:17 AM
#2
They are sealed, you'll need to use either heat gun or put them in the oven to melt the seal
-
18th January 2012, 09:10 PM
#3
Thanks Rocky, I left them out in the afternoon sun and was able to slowly prise them apart with a few screwdrivers.
Just gotta do the same for the ones on the car, clean them up and seal the new covers on
-
19th January 2012, 10:40 PM
#4
Just finished the job, used Sikaflex 227 to stick it all back together after digging out a lot of the old sealant.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Search AULRO.com ONLY!
|
Search All the Web!
|
Bookmarks