Slick Rock Sway Bar Disconnects

when i fitted my extended frnt springs i had to drop the centre crossmember out so the front tailshaft would come down far enough to let me put the springs in. so my guess is the crossmember might also be an issue.

Quote:

---

Originally Posted by Urban Panzer

I have them on mine, fitted them when I ripped the ACE system off as they are far more substantial than the crappy standard links.

Be aware tho, if you have longer travel shocks, and disconnect the roll bar, the front springs will dislocate, so "Imo" you need to fit them inconjunction with either front spring retainers, or dislocation cones.

---

Thanks Nick,

I'm running a 2 inch lift at the moment...will that be an issue with the disconnects?
I have access to a fork lift so after I do the install I can test the flex/movement to see if there are any problems...
If there is an issue do have any recommendations for retainers/cones??

I'm offshore at the moment so it will three weeks or so until I start the job

Dave

Quote:

---

Originally Posted by MR LR jnr.

The shocks are your limit straps basically, when the axle drops (say you jumped the thing!!) they're the only thing holding the axle from rotating the hole way under the truck...

---

and that is different to a discovery 1 that never had swaybars in what way ?

Quote:

---

Originally Posted by assafde

Take under consideration while you drive with the links disconnected the only thing that holds your axle are your shocks...

---

As Roscoe said, RRC's, D1's, 90/110's and plenty of other cars never had anti-roll bars fitted so I'm not quite sure what your point is ?

Getting APT Fabrication in Brissy to make some front spring retainers (bottom).
They do them for $18 for D1, RRC etc so would assume it would be about the same $$. Should be next week sometime.

I'll report back in case others are interested.

Cheers,
Matt

Thanks for that Matt. Let me know how you get on mate.