I use super glue to retain difficult rocker cover gaskets into the cover. A drop or thin line every inch or so, hold each section until set, then refit cover. Adds about 5 minutes to the job.
Printable View
I use super glue to retain difficult rocker cover gaskets into the cover. A drop or thin line every inch or so, hold each section until set, then refit cover. Adds about 5 minutes to the job.
As Justin C said earlier, there are 2 different ones subject to vin.
Part number ERR7094 for up to Vin 1A736339
Part number LVP000020 for Vin 2A736340 on
check the part number you purchased against your vin number.
regards, Mario
Yep got the correct gasket , thanks to the good people at roverlordoffroadspares. OVERNIGHT.
Could not get it in the little dimple at the back of the motor.
Took the gasket back off and placed in in the dimple on the block and then into the bolt locators. Starting at the rear I put all of the other steel locators in place with the rear bolts just started in their threads. Making sure to be careful near the cam chain I lowered it all into place and finished off tightening it all back down. Job finally done.
Thanks Guys for all your help. Regards Nick.