Results 1 to 3 of 3

Thread: Air Suspension sensor reading staying the same

  1. 15th December 2012, 10:08 AM #1
    Chilly
    Chilly is offline Master Subscriber
    Join Date
    Feb 2008
    Location
    Golden Beach, QLD 4551
    Posts
    672
    Total Downloaded
    0

    Air Suspension sensor reading staying the same

    Hi,

    I have a rear right air suspension height sensor reading the same. 253.
    I have tried another sensor and still does not change the result.
    I then tried sensor on left side. Read ok. Whilst both sensors disconnected I got 253 reading on both sides.
    So I am guessing an connection problem or ECU?

    Anyone had this problem?

    Ideas on where to check?

    Cheers,

    Chilly
    Reply With Quote Reply With Quote
  2. 16th December 2012, 08:22 PM #2
    Chilly
    Chilly is offline Master Subscriber
    Join Date
    Feb 2008
    Location
    Golden Beach, QLD 4551
    Posts
    672
    Total Downloaded
    0
    Well, have done a bit of checking. Looks Like I have a Earth lead broken. From the ECU to the Sensor.

    Will look a bit further tomorrow. Anyone pulled the connector on the sensor apart.....just in case it is broken internally.
    Reply With Quote Reply With Quote
  3. 17th December 2012, 04:32 PM #3
    Chilly
    Chilly is offline Master Subscriber
    Join Date
    Feb 2008
    Location
    Golden Beach, QLD 4551
    Posts
    672
    Total Downloaded
    0
    Well, Success.

    Checked out the wiring...all connections good thankfully. Traced to a broken wire located in the engine bay. Coming up in the main loom from the rear below the coolant bottle.

    Rejoined and all good now.

    Cheers,

    Chilly
    Reply With Quote Reply With Quote
« Is my TVD stuffed? | Donut replacement »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!