Using Nanocom Evolution to monitor manifold pressure kpa and MAF sensor kg/hr

Eight Run:

Seem to have had a slight step backwards:

AF: 642.5

TP: 221

EDIT:

9th run:

AF: 613.7

TP: 220.1

I'm starting to think that close enough is good enough - I'm going to just adjust the AF slightly and be done (the vehicle is driving perfectly, good power levels and EGT so should be fine). I could spend all night making minor adjustments otherwise, and then seasons, day temperature and humidity and what not might even effect it a bit.

Quote:

---

Originally Posted by OffTrack

I think the EVO samples more frequently when it is just displaying data. I'm not 100% on that, but it might be worth double checking using the peak reading button if you have just been going off the recordings.

---

I have read that when recording it records once every second.

What is the peak reading button? Is that one of the three little graph picture buttons down the bottom? I assume the peak reading button might be the one of the graph going up high? How does this function work?

You press the button and the Instrument display shows peak reading for 1or 2 seconds in the same session.
Regards Philip A

Quote:

---

Originally Posted by twr7cx

I have read that when recording it records once every second.

What is the peak reading button? Is that one of the three little graph picture buttons down the bottom? I assume the peak reading button might be the one of the graph going up high? How does this function work?

---

Yes the three graph buttons are the one you need. When you are viewing inputs the Evo stores the highest and lowest values that have occured since you opened the module. The graph button with the X clears the stored values, so you can reset between runs without exit the module. When I tried accessing peak values while recording the values wouldn't display, so it seems you can't do both at the same time.

cheers
Paul