TM1 mount and sensor positions

IMHO......The only issue I see with this is the WIRE will be just under or just over the heat shield..

And very close to the exhaust manifold.

My Oil pressure wires were completely fried and crusty from the heat down there.

Cheers.

Quote:

---

Originally Posted by NWTASD2

IMHO......The only issue I see with this is the WIRE will be just under or just over the heat shield..

And very close to the exhaust manifold.

My Oil pressure wires were completely fried and crusty from the heat down there.

Cheers.

---

The wire I put in split corrugated conduit above the rubber heater pipe about 100mm from the heat shield.

Or

Then run the wire around the front of the engine