Thread: Nanocom

Originally Posted by dearot

I still cannot clear the 3 amigos away probably I have to do option B

What fault code is coming up? Option B only fixes the faulty connector inside the abs modulator; not faulty earths, sensors etc

all air suspension stuff is located in slabs

Originally Posted by dearot

I just received my nanocom evo. Plugged in and saw a lot of faults and cleared them

I still cannot clear the 3 amigos away probably I have to do option B

I read somewhere that I can adjust (lowered and raised) the air suspension but I could remember where. I could not also find this option on nanocom. Anyone can tell me how? please

what do you mean you can't clear the 3 amigos?...you can not erase the fault code or you can erase but the 3 amigos are coming back instantly on self check then you get the same code back? ...this is important

as about the height calibration

WABCO SLABS - Diagnostic Capabilities (UTILITY)

SLS HEIGHT CALIBRATION
· Raise left: This function causes the SLABS ECU to energize the rear left corner valve
and the inlet valve. If there is pressure in the system the rear left hand corner will
raise.
· Lower left: This function causes the SLABS ECU to energize the rear left corner
valve and the exhaust valve. This will cause the rear left hand corner to lower.
· Raise right: This function causes the SLABS ECU to energize the rear right corner
valve and the inlet valve. If there is pressure in the system the rear right hand
corner will raise.
· Lower right: This function causes the SLABS ECU to energize the rear right corner
valve and the exhaust valve. This will cause the rear right hand corner to lower.
· Store heights: This function sends a command to the SLABS ECU to store the
actual heights.

3 amigos just stay there after I cleared the faults. I cant remember exactly the error message but I think it says something electrical. I will check again tonight after daughter's badminton lesson.

Hello,
You will have to go to the Auto box section and clear the faults for the gearbox it is how I clear my 3 amigos fault. I have the switch fault but never get around to fixing it yet.
Ian

Its shutle valve electrical fail.

I dont have any error on the auto box.

The lowering of suspension, is the transport mode setting, it deflates the airbags and rests the chassis on the bump stops. No good if you have coils though.

You need to do some light reading,,
TGO.
The 3 amigo dash lights stay on regardless after XXX amount of faults,,