Thread: disco 2 td5

Have you plugged in your inj harness to the injectors, and the head terminal?.
No cam sensor on td5

Yes have cleaned the Injector harness plug with contact cleaner and checked it again. Would the crank angle sensor give this error?

Cheers

Nothing else than injector open circuit would give you those fault codes as the ECU monitors the solenoids... imo the question is if you are 100% sure that you plugged each injector's solenoid to the harness before you refitted the rocker cover?

You may knocked the inertia switch on the firewall?.....try a reset.

You can try to fire the injectors one by one with nanocom and if you dont hear the click the circuit between the ECM and solenoids is open somewhere

Starting to sort this out. Have made a little progress. Took value cover off, checked injector connections ok. Sprayed all with terminal cleaner just in case but could not see a fault. Back together. Pressed the inertia button. Turned engine over with no faults recorded on the Nanocom. Fired the injectors with Nanocom and all give a click. Tries to start again but still no go. Just winds over with no hint of firing. Starting to tear what little hair I have left out.
I parked it up running ok but run out of ideas now.

purge again then crank it and if it doesnt start in 5 seconds keep cranking anf fully depress the throttle, dont keep it more than 10 seconds this way if still no joy we'll speak again

You probably know this but have you done the ign on acc pedal to the floor 5 times fuel bleed , do that then ign off , back on and crank with full throttle , should start. .
Cheers