Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: disco 2 td5

  1. 14th October 2015, 09:04 PM #11
    Jazzman
    Jazzman is offline Wizard Silver Subscriber
    Join Date
    Jun 2011
    Location
    Victoria - Pakenham
    Posts
    1,268
    Total Downloaded
    0
    I tried all this when I rebuilt my engine (with a lot of help from Discorevy) and in vain depressed the throttle to the floor and held it there while cranking. After not to long it sounded like it wanted to start but still no go. After that I pumped the peddle. Than it started.
    Reply With Quote Reply With Quote
  2. 15th October 2015, 11:09 AM #12
    devo's Avatar
    devo
    devo is offline Fossicker
    Join Date
    Jul 2011
    Location
    Mandurah WA
    Posts
    73
    Total Downloaded
    0

    Success

    Now running. I did not wind it over long enough the first time I tried the (ignition, 5 pumps, ignition off then on and start). Was concerned about overheating the starter. Just needed to wind engine over a little longer and away it went.
    Thanks to AULRO, Jazzman, discorevy, sierrafery and eddy for your input. Your knowledge has been invaluable over the years.

    Cheers
    Devo
    Reply With Quote Reply With Quote
  3. 15th October 2015, 08:47 PM #13
    Nomad9's Avatar
    Nomad9
    Nomad9 is offline Wizard
    Join Date
    May 2007
    Location
    Byford, WA
    Posts
    1,317
    Total Downloaded
    0
    Hi Eddy,
    So that's what that is................ha!!! Thank you.

    I had a similar problem to the one Devo is having and found a problem with the crankshaft angle sensor, accidentally knocked it...............

    Cheers Marty.
    Reply With Quote Reply With Quote
Page 2 of 2 FirstFirst 12
« D2 Wheel/Tyre advice | Finally no more squeaks »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!