Thread: D2 V8 Engine Harness wiring diagram help

My guess (I have a Td5 so can't look) but the plug with Red and Blue cables is for the drivers side coil (RHD).

I'm basing this on the fact this plug would have been located on the drivers side from the factory, the other plug on the passenger side.

Photos in RAVE shows C052 on the LHS and C156 on the RHS,

Thanks guys, it gets confusing as right hand side can be on either side, depending on if standing at front of vehicle ( which I assume is correct) as opposed to sitting in the drivers seat.
I always took it that standing in front of vehicle is where left and right sides are determined.

I asked as Nanocom reckons my O2 sensors are switched, and reading the wiring diagram, standing in front of the vehicle, left O2 sensor wiring colours are on the drivers side, Which is left when viewing from front ( drivers side RHD)

The loom was swapped before, and I'm checking to make sure it wasn't rolled over and the plugs where on the incorrect ) 2 sensors.
Thanks Mario

Originally Posted by Roverlord off road spares

Thanks guys, it gets confusing as right hand side can be on either side, depending on if standing at front of vehicle ( which I assume is correct) as opposed to sitting in the drivers seat.
I always took it that standing in front of vehicle is where left and right sides are determined.

No! Direction is always viewed from the driver's seat.

Originally Posted by Roverlord off road spares

I asked as Nanocom reckons my O2 sensors are switched, and reading the wiring diagram, standing in front of the vehicle, left O2 sensor wiring colours are on the drivers side, Which is left when viewing from front ( drivers side RHD)

Then Nanocom is correct, they are swapped.

Here are the relevant pics from RAVE.

Originally Posted by p38arover

No! Direction is always viewed from the driver's seat.

That is golden information to someone selling spares
As he states the side of vehicle is always viewed from sitting in the seats

Would be a bit problematic if you were a surgeon :-)

Originally Posted by p38arover

No! Direction is always viewed from the driver's seat.



Then Nanocom is correct, they are swapped.

Cleared faults, went for a drive and there is no mention of swapped sensors coming up now.

I'm confused. We started with coil packs and ended with O2 sensors.